9006 low and 9005 high beam to H4

9006 low 9005 to H4

9006 low 9005 to H4

This will allow you to install a H4 bulb in place of your 9005 and 9006 bulbs. 9005 and 9006 sockets plug into your harness, H4 socket plugs into your H4 bulb. Made with 14 gauge SXL wire, terminals are crimped and soldered and loom is installed to protect the wires.

Note: if your low beam stays on with your high beams it will overheat the H4 bulb and possibly damage the socket and wires.I recomend the relayed version.

To build these I will need the following info from your factory harness: You will need a volt meter you can check these. Are your cars headlights power or ground trigger. On the low beam socket 9006 what wire is the power. (the socket is marked with “A” or “B” were the wire go into the socket) On the high beam socket 9005 what wire is the power. (the socket is marked with “A” or “B” were the wire go into the socket)

9005 and 9006 sockets with “A” and “B” marked

H4 is the same as 9003, 6014, 6006

$50.00 pair (2 harness)

Please email with the information required and your PayPal address and I will send an invoice.